IP03P POE Extender is designed to send and extend Ethernet network with POE can be established using existing cables up to 500M. You can use a two-wire cable (UTP cable, coax cable, telephone line, antenna cable, or bell wire) that is no longer in use to connect a 10/100Mbps POE device, IP telephone, PC…etc without having to lay any new cables. Extended pass through POE to allow a single POE source, such as a POE network switch (IEEE 802.3af/at) to provide power to both TX/RX and the IP/POE camera use. It is perfect solution for extended distance data and power transmission for warehouses, parking lots, campuses, casinos and many more.
|
Installation:
Installation View:
1. Connect IP03PT, IP03PR with any two wire cable at both ends before powering.
2.Power input source could use POE Injector/Switch either optional DC 48V, DC56 power adapter to IP03PR unit and camera use.
IP03PT with POE switch power input to IP03R and POE camera
IP03PT with DC 48/56V Power adapter power input to IP03R and POE camera
IP03PT with POE switch power input to IP03R and Non-POE IP camera. 
IP03PT with DC 48/56V Power adapter power input to IP03R and Non-POE IP camera
Different Two Wire Cables distance:
Please note the cable quality, length and diameter of two wires used all have an influence on the transfer of data and the POE output.
Coaxial cable
0.6 mm inner conductor
|
Data: 50 Mbps, Power: 13 W with 100 m
Data: 50 Mbps, Power: 11 W with 500 m
Data: 45 Mbps, Power: - |
Telephone line/bell wire
0.8 mm
|
with 50 m Data: 50 Mbps, Power: 13 W with 100 m
Data: 50 Mbps, Power: 13 W with 200 m
Data: 50 Mbps, Power: 13 W |
Installation cable
1.5 sqmm
|
with 50 m Data: 50 Mbps, Power: 13 W
with 100 m Data: 50 Mbps, Power: 13 W
with 200 m Data: 50 Mbps, Power: 13 W |
Network cable
Cat-7
|
with 200 m Data: 50 Mbps, Power: 13 W
with 300 m Data: 50 Mbps, Power: 13 W
with 500 m Data: 45 Mbps, Power: 12 W |
Panel View:
IP03T
 
IP03R
 
|
Unshielded Installations 
Rev. A
